Installation
en
15
Note:
The extractor hood's housing can be concealed
within the upper cabinet. In doing so, you must observe
the following:
■
The intermediate floor must not be placed on the
extractor hood's housing.
■
The front panel must not be secured to the housing.
■
Access must be available in order to change the
filter and for the after-sales service.
Appliance width 90 cm:
You must also screw the appliance to the wall-hanging
cupboards either side of it.
Changing the filter pull-out's limit stop
On some versions of the appliance, the limit stop for the
filter pull-out can be changed. Spacers are included
with these appliances in order to position the
appliance's handle strip flush with the fitted unit.
1.
Pull the filter pull-out towards you.
2.
Shorten the spacer to the required dimension and
insert it into the slot specified.
Connecting the pipes
Note:
If an aluminium pipe is used, smooth the area
where it is to be connected before you connect it.
Exhaust air pipe, dia. 150 mm (recommended size)
Fit the exhaust air pipe directly to the air-pipe connector
and seal the joint.
Exhaust air pipe, dia. 120 mm
1.
Fit the reducing connector directly to the air-pipe
connector.
2.
Attach the exhaust air pipe to the reducing
connector.
3.
Seal both joints appropriately.
Removing the appliance
1.
Disconnect the electrical connection.
2.
Disconnect the pipes.
3.
Remove the metal grease filter.
4.
Remove the protective caps from the fastening
elements.
5.
Remove the appliance; see section entitled
"Removing the appliance".
