Installation
en
13
Body wall thickness: 16 mm
1.
Screw the mounting pieces to the body on the left
and right.
¨
2.
Remove the tabs from the bottom of the mounting
pieces.
©
Body wall thickness: 19 mm
1.
Fold out the tabs on both of the mounting pieces.
¨
2.
Screw the mounting pieces to the body on the left
and right.
©
3.
Remove the tabs from the bottom of the mounting
pieces.
ª
Preparing the appliance
A handle strip must be screwed to the filter pull-out. This
handle strip can be one that is provided with the
appliance, or one that is available as an accessory.
1.
Use the screws provided to secure the handle strip
to the filter pull-out.
2.
Connect the power cord provided to the
appliance.
¨
3.
Use the strain relief to secure the power cord in
place.
©
5
Installation
Installation
Sliding the appliance up into place
1.
Slide the appliance up into place and make sure it is
positioned correctly.
¨
2.
Measure the distance between the appliance and
the wall, and mark this on the filler strip.
3.
If required, shorten the filler strip to the required
dimension.
©
$
%
[
PP
%
&
PP
[
PP
$
[
$
%
