Mounting and connecting the device
3.3 Installing a strain relief
Unified Comfort Panels
38
Operating Instructions, 03/2020, A5E46641217-AA
3.
Insert a mounting clip into the cutout provided on the device. Make sure it is in the correct
position; see the section "Positions of the mounting clips (Page 35)".
4.
To secure the mounting clip, tighten the grub screw with the slot screwdriver, torque
0.5 Nm.
5.
Repeat step 3 and 4 for all mounting clamps until all clamps are fastened.
6.
Check the fit of the mounting seal.
3.3
Installing a strain relief
The device's scope of delivery includes a strain relief plate with the required number of fixing
screws.
Note
If the strain relief plate of devices with display diagonal
≤
12" is mounted, then the strain
relief plate projects beyond the outer dimensions of the device. Screw on the strain relief
plate of the devices with display diagonal
≤
12" only after the device has been installed.
The strain relief plate of the devices with display diagonal
≥
15" can be screwed on before or
after the device has been installed.
Requirement
For mounting of the strain relief plate you need:
●
The strain relief plate from the scope of delivery
●
The supplied fixing screws
●
A torque screwdriver with T20 insert
