Technical Instructions
RCC10U Room Temperature Controller
Document Number 155-712
for Two-pipe Fan Coil Units
September 27, 2007
Page 10
Siemens Industry, Inc.
2-inch × 4-inch Electrical
Wall Box Mounting
An ARG70 wall plate adapter is recommended, but not required to mount an RCC10U
controller to a 2-inch × 4-inch electrical wall box.
1. Loosen the screw at the bottom of the controller with a small screwdriver.
2. Lift the bottom of the controller from the controller base and push up to remove. See
Figure 6.
3. Fasten the wall box adapter (3) to plaster ring (2), supplied by others, using the two
screws provided.
4. Flex adapter mask (4) and snap in place inside wall box adapter (3).
5. Pull wires through plaster ring (2).
6. Fasten controller base (5), to wall box adapter assembly (3) and (4) with the two
screws provided.
7. Follow Steps 7 through 9 of the
4-inch × 4-inch Electrical Wall Box Mounting
section
.
The installation is now complete.
Figure 10. 2-inch × 4-inch Electrical Wall Box Installation.
1 Electrical wall box
3 Wall box adapter*
4 Adapter mask*
* Included with ARG70
5
Controller base
6
Controller
