2/2
Operating Instructions
CB1B1433en_01 / 2013-07-05
Siemens Building Technologies
Receiver’s LED indication
State of receiver
State of LED
Power up (or reset)
The red and green LEDs flash alternately for 5 seconds, and then change to constantly red.
Note: If the receiver was programmed before, it will immediately change to constantly red.
Learning mode
Successful learning mode
The red and green LEDs flash alternately.
If RCR100FPRF learning was successful, the green LED will flash for 10 minutes.
Signal ok and output status change
The green LED is lit. If the output state changes, the green LED flashes for 3 seconds and then
changes back to constantly green.
Fail to receive wireless data
If the RCR100FPRF fails to receive wireless data, the red LED will start to flash after 125 minutes.
If the RCR100FPRF signal is recovered, it will resume the previous LED state.
