Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
228
Configuring GMRP for Specific Ethernet Ports
5
4
2
1
3
Figure 157: Global GMRP Parameters Form
1.
GMRP Enable Options
2.
RSTP Flooding Options
3.
Leave Timer Box
4.
Apply Button
5.
Reload Button
2. Configure the following parameter(s) as required:
Parameter
Description
GMRP Enable
Synopsis:
{ No, Yes }
Default:
No
Globally enable or disable GMRP.
When GMRP is globally disabled, GMRP configurations on
individual ports are ignored. When GMRP is globally enabled, each
port can be individually configured.
RSTP Flooding
Synopsis:
{ On, Off }
Default:
Off
This parameter specifies whether multicast streams will be
flooded out of all RSTP non-edge ports upon topology change
detection. Such flooding is desirable, if guaranteed multicast
stream delivery after topology change is most important.
Leave Timer
Synopsis:
600 to 300000 ms
Default:
4000 ms
Time (milliseconds) to wait after issuing Leave or LeaveAll before
removing registered multicast groups. If Join messages for
specific addresses are received before this timer expires, the
addresses will be kept registered.
3. Click
Apply
.
Section 5.8.2.4
Configuring GMRP for Specific Ethernet Ports
To configure GMRP for a specific Ethernet port, do the following:
1. Make sure the global settings for GMRP have been configured. For more information, refer to
.
2. Navigate to
Multicast Filtering
»
Configure Port GMRP Parameters
. The
Port GMRP Parameters
table
appears.
