RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Configuring VLANs for Specific Ethernet Ports
143
Section 5.1.4
Configuring VLANs for Specific Ethernet Ports
When a VLAN ID is assigned to an Ethernet port, the VLAN appears in the VLAN Summary table where it can be
further configured.
To configure a VLAN for a specific Ethernet port, do the following:
1. Navigate to
Virtual LANs
»
Configure Port VLAN Parameters
. The
Port VLAN Parameters
table appears.
Figure 83: Port VLAN Parameters Table
2. Select a port. The
Port VLAN Parameters
form appears.
7
6
4
3
2
1
5
Figure 84: Port VLAN Parameters Form
1.
Port(s) Box
2.
Type List
3.
PVID Box
4.
PVID Format Options
5.
GVRP List
6.
Apply Button
7.
Reload Button
3. Configure the following parameter(s) as required:
Parameter
Description
Port(s)
Synopsis:
Any combination of numbers valid for this parameter
The port number as seen on the front plate silkscreen of the
switch (or a list of ports, if aggregated in a port trunk).
Type
Synopsis:
{ Edge, Trunk, PVLANEdge, QinQ }
