Chapter 2
Installing the Subscriber Unit
RUGGEDCOM WIN5137-V
Installation Guide
10
Mounting the Subscriber Unit to a Pole
2
1
3
5
4
6
8
10
2
9
6
5
7
Figure 2: Mounting the Subscriber Unit to a Wall or Tower
1.
Subscriber Unit
2.
Mounting Kit
3.
Wall Holder/Pole Mount
4.
M8 × 25 mm Hex Screw
5.
M8 Spring Washer
6.
M8 Flat
Washer
7.
M8 Nut
8.
M5 Flat Washer
9.
NS 1/4" × 1/2" HEX Chipboard Screw
10.
Wall Anchor
2. Liberally apply an anti-corrosion spray to all galvanized steel components, including mounting brackets,
washers and screws.
3. Select a mounting location on the wall.
4. Place the mounting bracket on the wall and mark four mounting holes.
5. Drill four holes and insert a wall anchor into each hole.
6. Secure the mounting bracket to the wall with four 1/4" × 1/2" HEX screws, four spring washers, and four flat
washers.
7. Connect the arm bracket to the mounting bracket using a screw, spring washer, flat washer and nut. Make
sure the nut is hand tight
8. Connect the subscriber unit to the arm bracket using a screw, spring washer, flat washer and nut. Make sure
the nut is hand tight.
9. Make sure the subscriber unit is properly grounded according to local standards. For more information, refer
Section 2.6, “Grounding the Subscriber Unit”
10. Tighten the screws connecting the arm bracket to the subscriber unit and mounting bracket. Make sure the
screws are torqued to 24 N·m (17.7 ft. lb.).
Section 2.4.2
Mounting the Subscriber Unit to a Pole
The subscriber unit can be attached to any pipe or pole with a diameter of 44.5 to 254 mm (1.75 to 10 in).
To mount the subscriber unit to a pole, do the following:
