Chapter 3
Device Management
RUGGEDCOM WIN
User Guide
20
Viewing and Clearing RF Statistics
Parameter
Description
Next re-authentication
Displays the time remaining until the next re-authentication.
Section 3.3.2
Viewing and Clearing RF Statistics
To view and clear RF statistics, do the following:
1. Navigate to
Statistics » RF
. The
RF
screen appears.
Figure 13: RF Screen
2. View the RF statistics for the device:
Parameter
Description
CPE Status
Synopsis:
{Init, DL Synchronization, Handover DL acquisition, UL Acquisition, Ranging,
Handover ranging, Capabilities negotiation, Authorization, Registration, DHCP, TOD,
TFTP, Operational, Sleep, IDLE, Aborted}
Displays the current SS status.
DL RSSI
Displays the downlink received signal strength, in dBm.
DL CINR
Displays the downlink carrier to interference and noise ratio, in dB.
DL CINR R3
Displays Displays R3 downlink carrier to interference and noise ratio, in dB.
MIMO mode
Synopsis:
{SISO, MIMO A, MIMO B}
Displays the SS Multiple-Input, Multiple-Output mode.
TX Power [dBm]
Displays the SS transmission power, in dBm.
UL MCS
Synopsis:
{N/A, QPSK-CTC-1/2, QPSK-CTC-3/4, QAM16-CTC-1/2, QAM16-CTC-3/4,
QAM64-CTC-2/3, QAM64-CTC-3/4, QAM64-CTC-5/6}
Displays the uplink Modulation and Coding Scheme.
DL MCS
Synopsis:
{N/A, QPSK-CTC-1/2, QPSK-CTC-3/4, QAM16-CTC-1/2, QAM16-CTC-3/4,
QAM64-CTC-2/3, QAM64-CTC-3/4, QAM64-CTC-5/6}