Chapter 5
Setup and Configuration
RUGGEDCOM WIN
User Guide
62
Disconnecting from Specific Base Stations
2
1
3
4
6
7
8
5
Figure 54: Allowed BS Screen
1.
Connect only to allowed BS List
2.
Allowed BS List Table
3.
Add Button
4.
Delete Button
5.
Connect only to allowed
Operator ID Box
6.
Apply Button
7.
Connect Button
8.
Disconnect Button
3. Set the
Connect only to allowed BS
option box to
Enable
.
4. Select a base station ID from the
Allowed BS List
table.
5. Click
Connect
.
Section 5.3.5
Disconnecting from Specific Base Stations
The
Allowed BS List
table provides a list of specific base stations to connect to. When the device is connected to
these base stations, clicking
Disconnect
disconnects the RUGGEDCOM WIN from all base stations the device is
currently connected to.
CAUTION!
Connection Loss Hazard - Risk of data loss or failure of functioning processes. Clicking
Disconnect
while using the RF interface will stop the RUGGEDCOM WIN from transmitting and the RUGGEDCOM
WIN will lose its connection to the base station(s). A hard reset (shutting down and then powering
up) or a site visit will be required to reboot the RUGGEDCOM WIN using the GUI. Before clicking
Disconnect
, make sure you are not using the RF Interface.
To disconnect from base stations, do the following:
1. Navigate to
WiMAX » Allowed BS
. The
Allowed BS
screen appears.