Chapter 5
Setup and Configuration
RUGGEDCOM WIN
User Guide
68
Configuring the LAN Gateway
Figure 61: Failover BS Support Screen
2. Configure the following parameters as needed:
Parameter
Description
Failover BS Support
Synopsis:
{ Enable, Disable }
Enables or disables Failover BS Support.
Maps Lost Timeout
Synopsis:
{ 100, 600, 5000 }
The time in milliseconds (ms) to wait after losing the WiMAX map
before connecting to one of the serving base station neighbors
previously scanned from the Neighbor BS table.
Scanning Interval
Synopsis:
{ 1, 5, 60 }
The time in minutes (min) to wait after de-registering from a base
station before scanning for a new base station neighbor.
3. Click
Apply
.
4. For each base station neighbor, make sure the Operational Mode for each neighbor defined in the Neighbor
BS table is set to Auto. For more information, refer to the
RUGGEDCOM WIN v5.0 User Guide
for base
stations.
Section 5.9
Configuring the LAN Gateway
Use the LAN gateway to access a remote subnet or a specific IP address behind a router. To configure the
destination subnet and the LAN gateway, do the following:
1. Navigate to
Network » LAN Gateway
. The
LAN Gateway
screen appears.