Chapter 5
Setup and Configuration
RUGGEDCOM WIN
User Guide
82
Configuring DSCP Marking
Parameter
Description
sysUpTime
Displays the length of time, in hundredths of a second, since the
SNMP subsystem was last initialized.
Contact Details
Contains subscriber station contact information including name
and contact details.
Subscriber Station Name
Displays the subscriber station name.
Street Address
Contains the subscriber station street address or location
sysServices
Displays a value indicating the set of services provided by the
system. The value 2 indicates the datalink/subnetwork layer.
3. Click
Apply
.
Section 5.13
Configuring DSCP Marking
To configure Differentiated Services Code Point (DSCP) marking (identified outgoing management traffic), do the
following:
1. Navigate to
Management » Remote Management » DSCP Marking
. The
DSCP Marking
screen appears.
Figure 77: DSCP Marking Screen
2. In the
DSCP marking [0-63]
parameter, type a value in the range of 0 to 63. The default value is 48.
3. Click
Apply
.
Section 5.14
Configuring Network IP Addresses
To configure the LAN and RF IP addresses for the device, do the following:
NOTE
• Use the LAN IP address when you access the SS through a direct connection to its physical Ethernet
port.
• Use the RF IP address when you access the SS through the RF network.
1. Navigate to
Network
. The
IP Settings
screen appears.
