30
Requirements for Use
❏
This appliance must be connected to a 220/240 V
50 Hz mains electricity supply using an earthed
plug.
❏
It must be protected with a 10 A slow-action fuse.
❏
Should an extension lead be needed, this lead
must be at least 1,5 mm
2
per terminal thick, no
more than 25 m. long and earthed.
❏
There is a cavity at the back of the appliance for the
mains electricity supply connection wire.
❏
Do not allow water to enter the appliance.
❏
Do not block the air inlets or outlets on your
appliance, especially when used for heating.
Should the mains electricity supply wire be damaged
in any way, it must only be replaced with a wire of
similar characteristics. Get in touch with the
m a n u f a c t u r e r, after-sales service or similarly qualified
p e r s o n .
Fitting the batteries in the remote control:
❏
Remove the cover from the battery compartment on
the back of the remote control.
❏
Insert the 2 A A A (1.5 volt) batteries supplied with
your appliance.
❏
Replace the cover. The display screen will flash 12
o ’ c l o c k .
Wa r n i n g !
If the appliance is turned off and then turned back
on again, there is a 3-minute interval before the
compressor starts up again. This interval is
necessary in order for the appliance to work
p r o p e r l y.
Transportation
requirements
There are castors fitted on your appliance to make
moving it easier. If it is necessary to tilt your
appliance in order to move it, then the internal
water tank must be drained first. To do this, connect
drainage pipe to stopcock at the bottom of the
appliance.
Warning!
Be particularly careful when transporting this
unit. There is a water drainage pipe on the
bottom of the appliance which may break if
knocked.
Requirements for
use
+
