21
Location-Based-Service (lbs)
Commands
multicast
port
service
server-ip
show
Related commands
This section describes commands used to enable and configure a location-based service on a Wireless
Appliance and Wireless APs. These commands are located in the lbs context of the CLI. Execute the
lbs
command at the root level to enter lbs context.
Aeroscout and Ekahau are the currently-supported location-based servers.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the lbs context:
•
on page 377
•
on page 378
•
•
•
on page 379
For information on related commands that are available in other contexts, see
on
page 380.
multicast
Use the
multicast
command to set the location-based server multicast address. The
multicast
command is accessible from the lbs context of the CLI.
multicast 0x:0x:0x:0x:0x:0x
Parameters
0x:0x:0x:0x:0x:0x
Specifies the multicast address of the location-based server, in hexadecimal format.
SCALANCE WLC711 CLI Reference Guide
377
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...