26
Publish Commands
This section describes commands used in the publish context on a Wireless Appliance. These
commands are located in the publish context of the CLI. Execute the
publish
command in the location
context to enter the publish context.
Refer to the section “Using the RF Location Engine” in the
Wireless User Guide
for more information
about RF Location configuration.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the publish context:
•
on page 415
•
•
•
push
Use the
push
command to enable or disable the push operation on this controller. This command is
available from the location:publish context.
push (enable | disable)
Parameters
enable
|
disable
Enables or disables the push operation on this controller.
Examples
The following example enables the push operation on this controller:
WLC.siemens.com
:location:publish# push enable
SCALANCE WLC711 CLI Reference Guide
415
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
