DCS Commands
The commands in this section are common to radio1 and
radio2 dcs
commands in various contexts.
The following commands are variously available in the radio1 and radio2 dcs contexts:
•
on page 140
•
•
on page 141
•
•
•
Commands entered in the dcs context do not need to be followed by "apply" in order for them to take
effect.
channel_plan
Use the
channel_plan
command to customize the channel plan for the Wireless AP’s Radio 1. The
channel_plan
command is accessible from the ap:<serial> and ap:defaults:11n, ap37xx, ap38xx,
ap3801, , and std radio dcs contexts of the CLI.
The parameters available in the
channel_plan
command are determined by the setting of the
mode
command in the same radio context.
Syntax: (11n, 4102, ap37xx, ap38xx, ap3801, dualband, std, and <serial> radio1)
channel_plan all-non-dfs | all | channel[, channel]
Parameters
all-non-dfs
Radio 1 uses all non-DFS channels.
all
Radio 1 uses all channels
channel[, channel]
Radio 1 uses the channels that are listed, separated by commas.
Syntax: (11n, 4102, ap37xx, ap38xx, ap3801, dualband, std, and <serial> radio2)
channel_plan auto | 3-channel | 4-channel | channel[, channel]
Parameters
auto
Radio 2 uses 3 channels for countries supporting 11 channels and 4 channels for
countries supporting 13 channels.
3-channel
Radio 2 uses 3 channels.
4-channel
Radio 2 uses 4 channels.
channel [,channel]
Radio 2 uses the channels that are listed, separated by commas.
ap Commands
DCS Commands
SCALANCE WLC711 CLI Reference Guide
140
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
