Parameters
vns name
Specifies a name for this VNS
wlans
WLANS name
Specifies a WLAN Service for this VNS
pol
role-name
Specifies the non-authentication role for this VNS
Usage
When you create a VNS, if the referenced WLAN Service has a mode of:
•
“std” then the referenced role must have a topology of mode “b@ap,” “b@ac,” or “routed”
•
“3pap” then the referenced role must have a physical topology mode
•
“wds” then the referenced role must have a null topology
Example
The following example creates a VNS named testvns and assigns it a WLAN Service named “WLC-1”
and a role named “NonAuth”:
WLC.siemens.com
:vnsmode# create testvns wlans WLC-1 pol NonAuth
das
Use the
das
command to configure DAS (Dynamic Authorization Server) settings. Executing the
das
command puts you in the vnsmode:das context where the following commands are available.
The following commands are available in the vnsmode:das context:
•
on page 242
•
port
Use the
port
command to configure the DAS port. The
port
command is available from the
vnsmode:das context.
port 1024-65535
Parameters
1024-65535
Specifies the DAS port.
Examples
The following example sets the DAS port number to 3799:
WLC.siemens.com
:vnsmode:das# port 3799
VNS Commands (vnsmode)
das
SCALANCE WLC711 CLI Reference Guide
242
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
