The global setting of Radius Accounting must be enabled prior to using this command. Defer
accounting start is disabled by default.
defer-acct-start (enable | disable)
Parameters
enable
Enables the defer accounting start feature.
disable
Disables the defer accounting start feature.
Examples
The following example enables defer accounting start:
WLC.siemens.com
:vnsmode:radius# defer-acct-start enable
delay-client-msg
Use the
delay-client-msg
command to set the delay, in seconds, for the client message that displays
if a topology change occurs during athentication. The
delay-client-msg
command is accessible from
the vnsmode:radius context of the CLI.
delay-client-msg 1-60
Parameters
1-60
The time, in seconds, that the client message displays if a topology change occurs
during athentication.
Examples
The following example sets the delay to 40 seconds:
WLC.siemens.com
:vnsmode:radius# delay-client-msg 40
delete
Use the
delete
command to delete a RADIUS server configuration. The
delete
command is accessible
from the vnsmode:radius context of the CLI.
delete RADIUS_server
Parameters
RADIUS_server
Specifies the name of the RADIUS server to delete
VNS Commands (vnsmode)
delay-client-msg
SCALANCE WLC711 CLI Reference Guide
251
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
