l3presence
As of Release 9.21, you can access Layer 3 on a b@ac topology when l3presence is disabled. For
releases prior to 9.21, you must enable Layer 3 on a b@ac topology to access Layer 3 commands in the
topology:<named-topology>:l3 context. Use the
l3presence
command to enable or disable Layer 3 on
a b@ac topology. The
l3presence
command is available from the topology:<named-topology>
context of the CLI for b@ac topologies.
l3presence enable | disable
Parameters
enable
Enables Layer 3.
disable
Disables Layer 3.
Example
The following example enables Layer 3 on a b@ac topology:
WLC.siemens.com
:topology:bridged_ac1# l3presence enable
mode
Use the
mode
command to change the mode of an existing b@ac, b@ap, or routed topology. You can
configure the mode of a topology only if the topology is not associated with a policy. The
mode
command is available from the topology:<named-topology> context of the CLI for b@ac, b@ap, and
routed topologies.
mode b@ap |
b@ac
|
routed
Parameters
b@ap
|
b@ac
|
routed
Specifies the mode of the topology.
Example
The following example changes the mode of the topology to b@ap:
WLC.siemens.com
:topology:bridged_ac1# mode b@ap
name
Use the
name
command to change the name of an existing b@ac, b@ap, or routed topology. The
name
command is available from the topology:<named-topology> context of the CLI for b@ac, b@ap, and
routed topologies.
name topology name
Parameters
topology name
Specifies the name of the topology.
topology Commands
l3presence
SCALANCE WLC711 CLI Reference Guide
370
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...