stationlog
Enables or disables station session event reporting on the controller station events
log.
send_station_trap
Enables or disables station event forwarding as SNMP traps.
Examples
The following example sets the Wireless Appliance's log level to Minor:
WLC.siemens.com
# loglevel ac 3
Successfully set ac log level to Minor (3)
The following example sets the Wireless Appliance log level to Information and enables station event
reporting on the the controller station log:
WLC.siemens.com
# loglevel ac 4 stationlog enable
The following example sets the AP’s log level to Information:
WLC.siemens.com
# loglevel ap 4
ping
Use the
ping
command to ping an IP address. The ping command accepts an optional parameter that
specifies the source ip address to be used by the command. If this optional source is provided, ping
uses the IP address of the specified interface as the source IP address.
ping source-interface name name | number id ip address
Parameters
source-interface
name
name
|
number
id
Specifies the address of the source interface you want to send pings
from, either by interface name or ID.
IP Address
Specifies the IP address you want to ping. The IP address can be
either IPv4 (A.B.C.D) or IPv6 (A:B:C:D:E:F:G:H) format.
Usage
You can identify the source IP using its interface name or, for short, the identifier returned by the
show
topology l3
command. Interface name is the name of any topology with L3 configuration (Physical,
Admin, B@AC or Routed).
radtest
Use the
radtest
command to test the RADIUS server’s connectivity and configuration.
radtest vns_name | username | password
root Commands
ping
SCALANCE WLC711 CLI Reference Guide
39
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
