location-engine (enable | disable)
Parameters
enable
|
disable
Enables or disables the location engine on this controller.
Examples
The following example enables the RF location engine:
WLC.siemens.com
:location# location-engine enable
default-height
Use the
default-height
command to set the default height of the APs from the floor, for use if the
floor plan does not specify a height for APs. The
default-height
command is accessible from the
location context of the CLI.
default-height centimeters
Parameters
centimeters
Specifies the default height, in centimeters, of APs from the floor. Valid values are 0
- 1000.
Usage
If the floor plan specifies a height for AP placement, that value will be used. If there is no floor plan, or
the floor plan does not specify AP placement heights, then this command applies. The default value for
the <centimeters> parameter is 3.
Examples
The following example sets the default height of APs to 06 centimeters:
WLC.siemens.com
:location# default-height 06
WLC.siemens.com
:location# apply
auto-tracking
Use the
auto-tracking
command to enable or disable auto-tracking. When auto-tracking is enabled,
the RF Location engine tracks and reports the location of all associated users (users with sessions on
the controller), up to the system limit (2,500).
The
auto-tracking
command is accessible from the location context.
auto-tracking (enable | disable)
RF Location Commands
default-height
SCALANCE WLC711 CLI Reference Guide
410
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
