Examples
This example enables the
mac-list-sync-mode
:
WLC.siemens.com
:ap:blacklist# mac-list-sync-mode enable
defaults
The
defaults
command moves you into the defaults context, which contains commands to configure
the Wireless AP’s default settings. The
defaults
command is accessible from the ap context of the
CLI.
As the Wireless APs discover and register with the controller, they inherit the properties of the default
Wireless AP setting. Since these defaults must apply to multiple AP platforms, they consist only of
values that are supported on all platforms. To apply options individually to an AP, you can modify the
default Wireless AP settings on that AP either via the Wireless Assistant GUI or the CLI <serial> context.
The following commands are available in the ap:defaults context:
•
on page 86 — See for commands in the ap:defaults:11n context.
•
on page 87 — See for commands in the ap:defaults:ap37xx context.
•
on page 87 — See ap38xx for commands in the ap:defaults:ap38xx context.
•
— See ap3801 for commands in the ap:defaults:ap3801 context.
•
on page 88 — See assign for commands in the ap:defaults: context.
•
on page 89 — See for commands in the ap:defaults:dualband context.
•
on page 90
•
•
•
on page 90 — See for commands in the ap:defaults:std context.
11n
The
11n
command moves you into context 11n, which contains commands to configure the default AP
settings for the Wireless 802.11n AP. The
11n
command is accessible from the ap:defaults context of the
CLI.
The following commands are available in the ap:defaults:11n context:
•
•
•
on page 108
•
on page 109
•
•
on page 109
•
•
•
on page 111
•
ap Commands
defaults
SCALANCE WLC711 CLI Reference Guide
86
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...
