name load group name
Parameters
load group name
The new name of the load group.
Usage
After you change the name of the load group and apply the change (with the
apply
command), the
ap:load-groups:<named-load-group> context retains the previous name of the load group. To change
the ap:load-groups:<named-load-group> context to the new name of the load group, you exit the
context and then enter the ap:load-groups:<named-load-group> context using the new name.
Example
The following example changes the name of loadgroup1 to lg_lab:
WLC.siemens.com
:ap:load-groups:loadgroup1# name lg_lab
WLC.siemens.com
:load-groups:loadgroup1# apply
WLC.siemens.com
:load-groups:loadgroup1# exit
WLC.siemens.com
:load-groups# ?
Available commands are:
create Create load group
delete Delete load group
end Return to the base mode
exit Return to the previous mode if not in the
base mode
lg_lab Configure details for load group lg_lab
logout Exit the shell
show
WLC.siemens.com
:ap:load-groups# lg_lab
WLC.siemens.com
:load-groups:lg_lab#
radio-load
Use this command to configure the maximum number of clients for each radio when the radio load
control feature is enabled. The
radio-load
command is accessible from the ap:load-groups:<named-
load-group> context of the CLI, for the radio type of load group.
radio-load radio1 | radio2 max-clients
Parameters
radio1
|
radio2
Specifies the radio being configured.
max-clients
Specifies the maximum number of clients for the specified radio. Can be an
integer between 5 and 60.
Usage
For access to this command, the radioN-loadcontrol command must be enabled.
ap Commands
radio-load
SCALANCE WLC711 CLI Reference Guide
96
Summary of Contents for scalance WLC711
Page 1: ...SCALANCE WLC711 CLI Reference Guide Release V9 21 14 C79000 G8976 C261 07 Published July 2015 ...
Page 21: ...dns 2 192 1 2 3 dns 3 192 1 3 3 Common Commands show SCALANCE WLC711 CLI Reference Guide 21 ...
Page 376: ...Example topology Commands vlanid SCALANCE WLC711 CLI Reference Guide 376 ...