Mounting
4.7 Changing the position of the securing bar
SCALANCE XC-100
28
Operating Instructions, 06/2016, C79000-G8976-C415-02
4.7
Changing the position of the securing bar
Rail mounting position - wall mounting position
To change the securing bar from the rail mounting position to the wall mounting position
follow the steps below:
1.
If necessary, loosen the knurled screw with your hand or a screwdriver.
2.
Move the securing bar down as far as it will go.
–
Use the levering aid and level the securing bar down using a screwdriver into this
position.
–
Push the securing bar down using your hand.
3.
Hold the securing bar in this position.
–
Hold the securing bar with the screwdriver.
–
Use the gap on the rear of the device and fix the securing bar briefly with a pin.
4.
Tighten the knurled screw (torque 0.5 Nm).
The securing bar is fixed in the wall mounting position.
5.
If applicable remove the pin.
Wall mounting position - rail mounting position
To move the securing bar from the wall mounting position to the rail mounting position,
loosen the knurled screw.
