Softening System NL
Water hardness °dH
Hardness range
mmol/l
Set value
7 - 8
9 - 10
11 - 12
13 - 16
17 - 21
22 - 30
31 - 50
soft
average
average
average
hard
hard
hard
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
H01
H02
H03
H04
H05
H06
H07
Remark: Set the device to the
determined water hardness.
With a water hardness of 0 - 6 °dH
you do not need to use softening
salt for dishwashers and you can
switch off the water softening.
softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the start of the
programme. The required amount of
softening salt depends on the water
hardness. The higher the water
hardness, the greater the amount of
softening salt required.
Set water softening
Set the appliance to the water
hardness.
1.
Determine the water hardness and
the desired setpoint.
PAY ATTENTION!
to press.
3.
Approx. 3 seconds on
s Dishwasher detergent can damage the water
damage hardening.
▶
The reservoir of the softener
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt for
dishwashers.
▶
To ensure that
spills out of the softening salt
from the rinse aid container, the
softening salt must be filled into
the water softening salt
reservoir immediately before the
program starts.
2.
on
Busy-
to access the basic settings.
a The display shows Hxx.
a The display shows
to give.
4.
Press as many times until
the desired water hardness has
been set.
The factory setting is H04.
5.
To save the settings, press for
approx. 3 seconds.
23