NL Softening System
1.
Open the lid of the softening salt
reservoir and remove it.
Switch off water softening
If the refilling salt display bothers you,
for example if you use a combined
dishwasher detergent with a salt
component, you can switch off the
display.
2.
3.
When using for the first time: fill
the reservoir completely with water.
Remark: Only use special salt
for dishwashers.
Do not use salt tablets. Do not
use table salt.
Remark
To avoid damage to the appliance,
only switch off the water softening
in the following cases:
Place the softening salt in the
softening salt reservoir.
s The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a degree of hardness of
21 °dH without adding softening
salt.
s The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
a
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
1.
on
to press.
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
4.
Fit and close the lid of the
reservoir.
a The display shows Hxx.
a The display shows
to give.
3.
Press as many times until
the display shows H00.
4.
To save the settings, press for
approx. 3 seconds.
a The water softener has been
switched on and the refilling salt
indicator is deactivated.
1
Depending on the device version
24
