Siemens SENTRON, Installation Manual

9

s 

l

 SEM3™ Metered Bus Plug for SENTRON Busway Systems

Figure 9: PC Output Port on Control Module

  TIP: An Ethernet switch may be used to collect output from  
  multiple controllers. Aggregated data can then be sent to  
  an upstream data management sytem via a CAT6 cable  
  from the Ethernet switch. Please see Section 8.0 for a  
  description of this network topology. 

7.1 ASSIGN STATIC IP ADDRESSES

  To change the PC/computer’s IP address: (in Windows 7/8).

  1) Type "network and sharing" into the Search box in the Start
     Menu and select Network and Sharing Center when    
  displayed.

  2) Then when the Network and Sharing Center opens, click on  
    Change adapter settings.

  3) Right-click on your local adapter and select Properties.
 
  4) In the Local Area Connection Properties window highlight  
    Internet Protocol Version 4 (TCP/IPv4), then click the    
  Properties 

button.

  5) Select the radio button and enter the correct IP address.
    (Ex. 192.168.1.100, and Subnet mask 255.255.0.0. The PC  
    static IP address should be in the same IP address range as the  
  SEM3™ 

controller.)

  6) Click OK to close out of the Local Area Connections Properties  
  window.

  To confirm, open the command prompt and do an "ipconfig"  
  to see if the network adapter settings have been successfully  
 changed.