en
20
Time delay *
*
on applicable models
You can delay the start of the programme
in 1-hour steps up to 19 hours.
Switch on the appliance.
Press the timer programming button
3
until the digital display
4
jumps
to
.
Keep pressing the timer programming
button until the required time is
displayed.
To delete the timer programming,
keep pressing the button until
is displayed.
You can change your programme
selection at any time until the
programme starts.
End of programme
The end of the programme is indicated by
a buzzer. This function can be changed as
follows:–
Hold down Function button C
pressed and switch on main switch
1
, then let the buttons go.
Function Button C flashes, and the
digital display indicates the value
which was set at the factory
(semi-loud).
To change the setting:
Press Function button C .
Each depression of the button
increases the set value by one,
when
is reached, the display
jumps back to
(off).
Switch off the main switch
1
.
The set value is stored in the appliance.
Switching the dishwasher OFF
Several minutes after the programme has
ended:
Open the door when the programme
has ended.
Set main switch
1
to OFF.
Turn the water tap off.
(Does not apply when Aqua-Stop unit
has been fitted)
Remove dishes, etc. when they have
cooled down.
Interrupting the programme
Open the door. Caution! There is a risk
of water squirting out from inside the
appliance. Do not open the door fully
until the spray arm has stopped
rotating.
Set main switch
1
to OFF.
Indicator lights extinguish. The
programme is retained in the dish-
washer memory.
If the hot water was switched ON or the
appliance has already heated up and then
the appliance door opened, leave the door
ajar for several minutes and then close.
Otherwise, the appliance door may fly
open due to expansion.
In order to continue with the stored
programme, set the main switch to ON
again and close the door.
Cancel programme (Reset)
Only when the master switch is ON.
Press the A and C buttons
simultaneously, and hold them pressed
for approx. 3 seconds.
The numerical display shows
.
Close the door.
The programme continues for approx.
1 min.
When it has ended, set the main switch
1
to OFF.
Close the detergent compartment
30
.
To restart the dishwasher, set main switch
1
to ON again and select desired
programme.
Downloaded from DishWasher-Manual.com Manuals
