Operator panel keys
SIJECT 15/16 Operation Manual June, 2003
2-6
2.3 Screen
hot
keys
General
Press each key and corresponding screen will be displayed. If the screen
has more than one layer, use the soft keys of page down
to go to
the next layer. Press the page up key
at right to go back to the
previous screen.
Alarm key
Press Alarm key to enter
Alarm screen
, and the current alarm will be
displayed on this screen. Press F1 key to enter the event record screen,
and you can check the record of all events.
Temperature key
Press this key to enter
Temperature screen
where the set value of each
temperature channel can be input, and the actual value of temperature
channel can be displayed as well. In addition, you can choose the “heat
holding” function, and you can set the tolerance of temperature control.
You can also choose the control mode of nozzle (open loop/close loop).
Timer key
Press this key to enter
Timer screen
. Every time duration can be set,
such as cycle time, cooling time, mold open/close time, as well as every
delay time and monitoring time.
Counter key
Press this key to enter
Counter screen
. You can set the quantity of
products and the products of each mold. Also the current product
quantity, number of injection and products quantity after machine power
on can be displayed.
Function key
Press Function key to enter
Function screen
. The screen brightness,
language (Chinese/English), selection of robot and back light functions
can be set.
