SIMATIC HawkEye™ 1600T
System Components
2
Rev. 1E, Nov 2007
SIMATIC HawkEye™ 1600T Smart Camera Guide
2-9
•
Optional IntelliFind License Key (applies to HE1610TIS & HE1610TIH
only)
Power-on Sequence
Each stage of the power-on sequence drives the LEDs in a binary up-count
fashion according to Table 2–5. The LEDs illuminate before the test is executed
and remain in that pattern until the next test is run or an error condition is
detected and displayed.
Error Codes
In the event of an error being detected, the beeper beeps five times and an error
code (in binary form) representing the test that failed flashes on the LEDs. The
LEDs continue to flash until the QuicSet® button is pressed, at which point an
error message is logged to the serial port and the Diagnostic Monitor is launched.
Table 2–5 describes the Mode/Status LED power-on sequence and error codes.
TABLE 2–5.
Mode/Status LED Power-On Sequence & Error Codes
Mode
Fail
Pass
Trig
Test Performed
•
Data Line Test
•
Address Line Test
•
•
Bootloader CRC Check
•
Kernel CRC Check
•
•
RS-232 Internal Loopback
•
•
FPGA Load Test
•
•
•
FPGA PCI Config Test
•
FPGA Video Buffer Test
•
•
FPGA DMA Transfer Test
•
•
FPGA Expose Done Interrupt Test
•
•
•
FPGA Read Done Interrupt Test
Summary of Contents for SIMATIC HawkEye 1600T Series
