Operating the mobile client
5.3 Using the override function
Mobile Client900WXN
62
Operating Instructions, 04/2015, A5E35883103-AB
Setting down the device
Always set down the device as follows:
●
In the wall-mounting bracket according to section "Wall-mounting bracket (Page 15)"
●
In the magnetic wall-mounting bracket according to section "Magnetic wall bracket
(Page 17)"
If none of the two wall-mounting brackets is within reach, you can also set down the device
as shown below after attaching the three rubber strips according to section "Rubber strips
(Page 21)". The rubber strips keep the device from slipping.
5.3
Using the override function
You can use the "Override" function when the device is operated at an ambient temperature
outside the permitted range. The operator has to make this decision. The use of the override
function is logged by the device.
Requirement
●
The connecting cable is connected.
●
The two on/off buttons have been pressed and held down for at least 0.5 seconds.
●
The "TEMP" LED is on.
●
The "PWR" LED is flashing.
