Overview
1.8.2 Example: RX15xx Services and WAN Networking
Figure 1.4
Example Configuration
In this scenario, the RUGGEDCOM APE1808 is reached via a routed interface. This is
accomplished by moving the RUGGEDCOM APE1808 port onto its own VLAN, and
creating a point-to-point connection between it and the control module.
The figure shows six serial ports available on serial LM 3. In order to become net-
work-accessible, these ports must be configured as socket ports that allow incoming
calls on TCP ports 5001 (ser-3-1) through 5006 (ser-3-6). While any address on the
RX1500 control module may be used to connect the RUGGEDCOM APE1808 to these
ports, switch.0001, switch.0002, and dummy0 addresses are recommended. In par-
ticular, dummy0 addresses are useful when router redundancy is implemented.
As in the previous scenario, devices on the 192.168.0.0/24 subnet are still available
to the RUGGEDCOM APE1808; however, in this scenario, they are available through
routing.
RUGGEDCOM APE1808
Configuration Manual, 11/2019, C79000-G8976-1415-03
9
