Installing the Device
2.3.2 Mounting the Device to a Panel
2.3.2
Mounting the Device to a Panel
To mount the device to a panel, do the following:
1. Disassemble the device and panel adapter.
a. Remove the screw at the bottom of the adapter.
b. Pull the device out of the adapter.
4
1
3
4
5
2
1
RUGGEDCOM RMC
2
Panel Adapter
3
Mounting Holes
4
Screw
5
Metal Clips
Figure 2.3
Panel Mounting
2. Place the panel adapter against the panel and align the adapater with the
mounting holes.
3. Secure the panel adapter using three #6-32 screws.
4. Insert the device into the adapter. Make sure the device is secured between the
two metal clips.
5. Install the screw previously removed from the bottom of the panel adapter.
2.4
Setting the Operating Mode
To accommodate a wide array of fiber optic devices, the RUGGEDCOM RMC is
equipped with a
MODE
switch located on the bottom of the device. The switch
configures the RUGGEDCOM RMC to accommodate different fiber partners that
RUGGEDCOM RMC
Installation Manual, 04/2021, C79000-G8976-1006-10
9
