Introduction to the SINAUT ST7 system
2.12 Standards and approvals of SINAUT ST7 products
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
109
Network compatibility
This product conforms to both the European standard TBR21 and national regulations
according to the European Telecommunications Standards Institute (ETSI) Guide EU
201121 (R&TTE Directive) This product therefore operates without problems in the PSTN
network of all countries of the EU and in countries that support the TBR21 standard.
Approval for the USA
EXHIBIT J (FCC PART 68 REQUIREMENTS)
This equipment complies with Part 68 of the FCC Rules. On the soldering side of this
equipment is a label that contains, among other information, the FCC Registration Number
and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide
this information to your telephone company.
This equipment uses RJ12 plugs.
An FCC compliant telephone cord and modular plug are provided with this equipment. This
equipment is designed to be connected to the telephone network or premises wiring using a
compatible modular jack which is part 68 compliant. See installation instructions for details.
The REN is useful to determine the quantity of devices you may connect to your telephone
line and still have all those devices ring when your telephone number is called. In most, but
not all areas, the sum at the RENs of all devices connected to one line should not exceed
five (5.0). To be certain of the number of devices you may connect to your line, as
determined by the REN, you should contact your local telephone company to determine the
maximum REN for your calling area.
If your telephone equipment causes harm to the telephone network, the Telephone
Company may discontinue your service temporarily. If possible, they will notify you in
advance. But if advance notice is not practical, you will be notified as soon as possible. You
will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the proper functioning of your equipment. If they do, you will be
notified in advance to give you an opportunity to maintain uninterrupted telephone service.
If you experience trouble with this telephone equipment, please contact
SIEMENS Energy & Automation, Inc.
Factory Service Center
3000 Bill Garland Road
Johnson City, Tennessee 37605
Tel: (423) 461-3000
for information on obtaining service or repairs. The telephone company may ask that you
disconnect this equipment from the network until the problem has been corrected or until you
are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company.
Connection to party lines is subject to state tariffs.
