Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
74
Configuration Manual, 10/2015, C79000-G8976-C351-05
3.2.5
Commands in the LOADSAVE configuration mode
This section describes commands that you can call up in the LOADSAVE configuration
mode.
In the Global Configuration mode, enter the
loadsave
command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode
with the global command
show loadsave tftp
.
●
If you exit the LOADSAVE configuration mode with the
exit
command, you return to the
Global Configuration mode.
●
If you exit the LOADSAVE configuration mode with the
end
command, you return to the
Privileged EXEC mode.
3.2.5.1
delete
Description
With this command, you call up the possible files or delete a specific file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
showfiles
Shows the available files
-
filetype
Keyword for the file type to be deleted -
filetype
Name of the file type
max. 100 characters
Result
The files are displayed or the file is deleted.
Further notes
With the "
show loadsave files
" command, you can display the file types.
