Communications Mode
CP 523
The following procedure is recommended:
1.
Enter the parameter setting data on the programmer in DB 1 and include sufficient comments.
2.
Store DB 1 on diskette or hard disk.
3.
Transfer DB 1 to the memory submodule.
Table 7-6. Setting the CP 523 Parameters in Interpretive Mode on the Memory Submodule
0
Parameter block 0
6
2400
baud
0
Even
parity
0
No BUSY signal
1
RS-232-C (V.24) interface
0
7 data bits (11-bit frame)
0
Handshaking OFF
Explanation
Entry on the PG 685
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
:
KS = 'Parameters for the serial';
:
S
= 'Interface';
:
KS = ':0600100';
:
S
= 'Parameters XON/XOFF';
:
KS = ':2';
:
KH = 1113;
2
Parameter block 2
11
H
DC1 (XON character)
13
H
DC3 (XOFF character)
:
S
= 'Parameters for ASCII';
:
KS = 'mode';
:
S
= ':720030000';
:
KH =
0D0D;
7
Parameter block 7
2
Interpretive
mode
0030
D
Character delay time 300 ms
000
D
Message frame length 0
0D0D
H
End-of-text characters
(two carriage returns)
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
7-20
EWA 4NEB 811 6044-02a