5-21
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
5.2.1 Setting the Station No. and Switch 8
Use the bank of switches of the ET 200U interface module to set the station
number of your ET 200U station (
Figure 5-6). Set the station number in
binary code. Each of the first seven switches on the bank of switches has a
different positional value.
Positional value: 1
Positional value: 2
Positional value: 4
Positional value: 8
Positional value: 16
Positional value: 32
Positional value: 64
Table 5-8
When switch is pressed (ON): the positional value is switched on
1
2
3
4
5
6
7
8
When switch is “ON”
Figure 5-6 Location of the Bank of Switches for Setting the Station Number
(ET 200U)
Setting the Station
Number
ET 200U(DP Standard): Address Assignm.,Starting–Up, Diagnosing Faults Using COM ET 200
