Wiring
6.10 Front connector for the I/O modules
Automation system
148
System Manual, 12/2017, A5E03461182-AE
4.
Bring the front connector into the pre-wiring position. To do this, hook the front connector
into the bottom of the I/O module and swivel the front connector upward until the front
connector latches (Figure 3).
Result: In this position, the front connector still protrudes from the I/O module (Figure 4).
However, front connector and I/O module are not yet electrically connected. By means of
the pre-wiring position, you can easily wire the front connector.
Figure 6-9
Wiring front connectors for I/O modules without shield contact element
5.
Begin to completely wire the front connector.
6.
Put the strain relief around the cable harness, and pull the strain relief for the cable
harness tight.
Summary of Contents for Simatic S7-1500/ET 200MP
Page 1: ......
