Wiring
6.11 Marking the I/O modules
Automation system
158
System Manual, 12/2017, A5E03461182-AE
6.11
Marking the I/O modules
6.11.1
Labeling strips
Introduction
Mark the pin assignment of the I/O modules using labeling strips. You can label the labeling
strips as desired and slide them into the outside of the front cover.
The labeling strips are available in the following models:
●
Pre-prepared strips that are included with the I/O module as delivered.
●
DIN A4 sheets, pre-perforated strips for machine printing; see section Accessories/spare
Preparing and installing the labeling strip
Proceed as follows to prepare and install the labeling strips:
1.
Label the labeling strip.
You can print labeling strips for the modules in your project with STEP 7. The labeling
strips are exported to Microsoft Word DOCX files and printed from the text editing
program. You can find more information in the online help.
2.
With a pre-perforated strip: Separate the labeling strip from the sheet.
3.
Slide the labeling strip into the outside of the front cover.
①
Labeling strips
Figure 6-20 Marking with labeling strips
Summary of Contents for Simatic S7-1500/ET 200MP
Page 1: ......
