Configuring
7.1 Configuring the CPU
Automation system
166
System Manual, 12/2017, A5E03461182-AE
7.1.2
Address assignment
7.1.2.1
Addressing - overview
Introduction
In order to address the automation components or modules, they must have unique
addresses. The following section explains the various address areas.
I/O address
I/O addresses (input/output addresses) are required in the user program to read inputs and
set outputs.
STEP 7 automatically assigns input and output addresses when modules are configured.
Each module uses a continuous range of input and/or output addresses corresponding to its
volume of input and output data.
Figure 7-5
Example with input / output addresses from STEP 7
STEP 7 assigns the address areas of the modules by default to the process image partition 0
("Automatic updating"). This process image partition is updated in the main cycle of the CPU.
Device address (e.g., Ethernet address)
Device addresses are addresses of modules with interfaces to a subnet (e.g., IP address or
PROFIBUS address). They are required to address the various devices on a subnet, for
example, to download a user program.
Summary of Contents for Simatic S7-1500/ET 200MP
Page 1: ......
