Commissioning
11.6 CPU memory reset
Automation system
242
System Manual, 12/2017, A5E03461182-AE
11.6.2
Manual memory reset
Reason for manual memory reset
CPU memory reset is required to reset the CPU to its "original state".
CPU memory reset
CPU memory reset is possible:
●
Using the mode selector switch / mode selector keys
●
Using the display
●
Using STEP 7
Procedure using the mode selector
Note
Memory reset
↔ Reset to factory settings
The procedure described below also corresponds to the procedure for resetting to factory
settings:
•
Selector operation with inserted SIMATIC memory card: CPU executes a memory reset
•
Selector operation without inserted SIMATIC memory card: CPU executes reset to factory
settings
To perform a memory reset of the CPU using the mode selector, follow these steps:
1.
Set the mode selector to the STOP position.
Result: The RUN/STOP LED lights up yellow.
2.
Set the mode selector to the MRES position. Hold the selector in this position until the
RUN/STOP LED lights up for the 2nd time and remains continuously lit (this takes three
seconds). After this, release the selector.
3.
Within the next three seconds, switch the mode selector back to the MRES position, and
then back to STOP again.
Result: The CPU executes memory reset.
For information on resetting the CPU to factory settings, refer to the section Resetting the
CPU to factory settings (Page 293).
Summary of Contents for Simatic S7-1500/ET 200MP
Page 1: ......
