Wiring
6.10 Front connector for the I/O modules
Automation system
System Manual, 12/2017, A5E03461182-AE
151
Preparing front connectors for I/O modules with shield contact element
Watch video sequence
https://support.industry.siemens.com/cs/media/67462859_wiring_shield_web_en/start.htm
To prepare the front connector for wiring, follow these steps:
1.
Remove the connection separator from the lower part of the connector (Figure 1).
2.
Insert the power supply element (Figure 2).
3.
Insert the shielding bracket from below into the guiding groove of the front connector until
it latches into place (Figure 3).
4.
Place the included cable strain relief (cable tie) for the cable harness into the front
connector (Figure 4).
Figure 6-11 Preparing front connectors for I/O modules with shield contact element (1)
5.
Swing the front cover up until the front cover latches (Figure 5).
Summary of Contents for Simatic S7-1500/ET 200MP
Page 1: ......
