Protection
9.7 Protection by locking the CPU/interface module
Automation system
202
System Manual, 12/2017, A5E03461182-AE
Removing copy protection
To remove copy protection, follow these steps:
1.
Remove any existing Know-how protection (Page 197).
2.
Open the properties of the respective block.
3.
Select the "Protection" option under "General".
4.
In the "Copy protection" area, select the "No binding" entry from the drop-down list.
Figure 9-8
Removing copy protection
9.7
Protection by locking the CPU/interface module
Locking options
Protect your CPU/interface module from unauthorized access by additionally using a
sufficiently secured front cover.
You have e.g. the following options:
●
Affix a seal
●
Secure the front cover with a lock (shackle diameter: 3 mm)
Figure 9-9
Locking latch using a CPU as an example
Summary of Contents for Simatic S7-1500/ET 200MP
Page 1: ......
