Image 10-6 Detail X brush holder 1G.6, 1H.6 shaft heights 180 to 200
Table 10-2
Spare parts stator and rotor 1G.6, 1H.6, shaft heights 180 to 200
No.
Designation
No.
Designation
3.00
Rolling-contact bearing bush (locating
bearing)
8.60
Commutator
4.00
Rolling-contact bearing bush (floating
bearing)
10.02
Stator frame with main and commutating coil resistors
5.00
Bearing shield, drive end
10.16
Grounding connection
5.41
Louvered cover
10.53
Special lifting eye
5.45
Cover with seal
20.00
Terminal box
6.00
Bearing shield, non-drive end
24.00
Brushgear unit, complete
6.18
Fixing lug for grounding
24.20
Carbon brushes
6.43
Cover with seal
24.36
Multiple pocket brush holder
6.45
Cover with seal
24.50
Brush holder (brush rocker, complete)
8.00
Rotor, complete
24.60
Single-acting clamping shoes (clamp straps) for brush hold‐
er
Spare Parts
10.5 Stator and rotor, shaft heights 180 to 280
SIMOTICS DC 1GG6
110
Operating Instructions 02/2016
Summary of Contents for SIMOTICS DC 1GG6
