General specifications
● Pay attention to the instructions on the lubricant plate.
● Regrease in portions. The shaft must rotate so that the new grease can be distributed in
the bearings.
Regreasing the roller bearings prior to commissioning
● If the period between delivery and commissioning is more than a year and less than four
years:
– Re-grease the roller bearings with twice the amount of grease specified on the lubricant
plate.
– Check the bearing temperature, as far as possible.
Regreasing roller bearings before commissioning
You must regrease the roller bearings under the following conditions:
● If the machine has been in storage for more than four years.
● If the machine has not been stored in accordance with the specifications in the "Storage"
section.
Procedure
1. Remove the bearing, regreasing pipes, grease nipples and the bearing cap.
2. Flush out the old grease.
3. Check the bearings before regreasing. If necessary, install new bearings.
4. Lubricate the bearings and reinstall the bearing components.
See also
Transport and storage (Page 27)
7.4
Minimum radial forces for cylindrical roller bearings
Note
Maintaining the minimum radial forces
Operating roller bearings without a load can damage them. Maintain the minimum radial forces
specified when using cylindrical roller bearings.
Commissioning
7.4 Minimum radial forces for cylindrical roller bearings
SIMOTICS DC 1GG6
Operating Instructions 02/2016
65
Summary of Contents for SIMOTICS DC 1GG6
