Operation
8
When carrying out any work on the machine, observe the general safety instructions
(Page 15) and the specifications contained in EN 50110‑1 regarding safe operation of electrical
equipment.
WARNING
Live parts
Terminal boxes accommodate live parts and components. If you open the terminal box cover,
this can result in death, serious injury or material damage.
● When the machine is in operation, the terminal boxes must remain closed at all times.
Terminal boxes may be opened only when the machine is stopped and de-energized.
WARNING
Rotating and live parts
Rotating or live parts are dangerous. If you remove the required covers, this can result in
death, serious injury or material damage.
● Any covers that prevent live electrical or rotating parts from being touched, ensure
compliance with a particular degree of protection or are required for ensuring proper air
flows, and hence effective cooling, must not be opened during operation.
WARNING
Fire hazard resulting from hot surfaces
Certain parts of the machine become hot during operation. Severe burns can result from
contact with these parts.
● Check the temperature of parts before touching them. If required, apply suitable protective
measures.
● Allow the machine to cool before starting work on the machine.
WARNING
Faults in operation
Deviations from normal operation such as increased power consumption, temperatures or
vibrations, unusual noises or odors, tripping of monitoring devices, etc., indicate that the
machine is not functioning properly. This can cause faults which can result in eventual or
immediate death, serious injury or material damage.
● Immediately inform the maintenance personnel.
● If you are in doubt, immediately switch off the motor, being sure to observe the system-
specific safety conditions.
SIMOTICS DC 1GG6
Operating Instructions 02/2016
71
Summary of Contents for SIMOTICS DC 1GG6
