Service and maintenance
9.1 Safety instructions
SIMOTICS S-1FG1 servo geared motor
Operating Instructions, 07/2019, A5E47360747B AA
141
CAUTION
Injuries caused by stirred-up foreign bodies and dust when working with compressed air
When you clean using compressed air, this can stir up dust, metal chips and cleaning
agents, and so cause injuries.
•
When cleaning using compressed air, make sure you use suitable extraction equipment
and wear protective equipment (safety goggles, protective suit, etc.).
WARNING
Danger to life when lifting and transporting
Incorrect lifting and transport operations, and devices and equipment that are unsuitable or
damaged can result in death, severe injury and/or damage to property.
•
Lifting devices, ground conveyors, and load suspension equipment must comply with
requirements.
•
The maximum capacity of the lifting equipment and the load suspension device must
correspond to the weight of the motor (see the rating plate).
•
Do not attach any additional loads to the lifting equipment.
•
To hoist the motor, use suitable cable-guidance or spreading equipment, particularly if
the motor is equipped with built-on assemblies.
•
The motor must not be lifted or transported by means of the power connector or signal
connector.
•
Do not stand in the slewing range of hoisting gear or under suspended loads.
WARNING
Danger to life through incorrect or unused lifting points
Through incorrect or unused lifting points, the motor can fall and cause death, severe injury
and/or material damage
•
Lift and transport large motors using the eyebolts screwed on to the end shields.
•
Completely screw in the eyebolts and tighten by hand (approx. 8 Nm).
•
Do not use bent or damaged eyebolts.
•
Use only eyebolts with laminated fiber washers.
•
Loads applied transversely to the plane of the eyebolts are not permitted.
WARNING
Danger of injury due to suspended loads
While being transported, the motor can cause injury by moving.
•
Use only perfectly functioning hoisting and load suspension equipment dimensioned to
carry the motor load.
•
Do not stand under suspended loads or in their slewing range.
•
When placing down the motor, ensure that it cannot roll.
Summary of Contents for SIMOTICS S-1FG1
