Connecting SIMOVERT MASTERDRIVES MC to the Technology-CPU
Product Information, 03/2008, A5E00272072-05
5
Definitions and warnings
1
Qualified personnel
Commissioning and operation of the devices are to be carried out by qualified personnel
only.
"Qualified personnel" means those who are familiar with the installation, mounting,
commissioning, operation and maintenance of the SIMOVERT MASTERDRIVES product.
Then they must have the following appropriate qualifications:
● Trained and authorized to energize, de-energize, clear, ground and tag circuits and
equipment in accordance with established safety procedures.
● Trained in the proper care and use of protective equipment in accordance with
established safety procedures.
● First aid training.
Warnings are not explicitly given in this documentation. However, you are strongly advised to
note the warnings contained in the Operating Instructions for each product from the
MASTERDRIVES series.
The script file to connect SIMOVERT MASTERDRIVES Motion Control to SIMATIC with the
standard telegram frame 5 is available at no cost. It may be copied, modified and used or
passed on to third-parties. However, in the case of it being passed on to a third party, it must
be in its full and unmodified form, and all copyright conditions must be observed. The
commercial distribution to a third party (for example in share/freeware distribution) is only
permitted with the previous written agreement of the Siemens AG.
As you have been given the script file for linking the SIMOVERT MASTERDRIVES Motion
Control to the SIMATIC with standard message frame 5 at no cost, the authors and rights
holders accept no liability for it. You use this file at your own risk and responsibility. The
authors and rights holders may only be held liable for criminal intent and gross negligence.
No further claims shall be accepted. In particular, the authors and rights holders shall not be
held liable for any defects or consequential losses.
Should you come across errors in the script file, please inform us.
