![background image](http://html.mh-extra.com/html/siemens/simpro-100/simpro-100_instruction-manual_383121197.webp)
SIMPRO-100
SIMPRO-PC Compatibility Features
D
PRIM-2400C
195
D.3.2
A5E0 Fast Operate Remote
Bit Control
Send the
A5E0
command to operate Remote Bits
RB1 – RB4. The
A5E0
command should contain
the items listed in Table D.9.
Table D.9
A5E0 Command
D.3.3
A5E3 Fast Operate
Breaker/Contactor Control
Send the
A5E3
command to stop or start the
protected motor. Motor starting is only effective if
a relay output contact is properly connected to
close the motor contactor or breaker.
The
A5E3
command should contain the items
Table D.10
A5E3 Command
D.3.4
ID Message
In response to the
ID
command, the
SIMPRO-100 Relay sends the firmware ID, boot
code ID, relay RID setting, the Modbus device
code, part number, and configuration as
described below.
where:
•
<STX> is the STX character (02)
•
<ETX> is the ETX character (03)
•
"yyyy" is the 4-byte ASCII hex
representation of the checksum for each
line
The ID message is available from Access Level 1
and higher.
Data
Description
A5E0
Command
06
Message length in bytes
1-byte
Operate Code
00
Clear RB1
01
Clear RB2
02
Clear RB3
03
Clear RB4
20
Set RB1
21
Set RB2
22
Set RB3
23
Set RB4
40
Pulse RB1
41
Pulse RB2
42
Pulse RB3
43
Pulse RB4
1-byte
Command validation (4 • Operate Code) + 1
1-byte
1-byte checksum of all preceding bytes
Data
Description
A5E3
Command
06
Message length in bytes
1-byte
Operate Code
31
Stop Motor
11
Start Motor
1-byte
Command validation (4 • Operate Code) + 1
1-byte
1-byte checksum of all preceding bytes
Summary of Contents for SIMPRO-100
