This manual supersedes PRIM-2400B issued October 1999.
IMPORTANT
The information contained herein is general in nature and not intended for specific application
purposes. It does not relieve the user of responsibility to use sound practices in application,
installation, operation, and maintenance of the equipment purchased. Siemens reserves the right to
make changes at any time without notice or obligations. Should a conflict arise between the general
information contained in this publication and the contents of drawings or supplementary material, or
both, the latter shall take precedence.
QUALIFIED PERSON
For the purposes of this manual, a qualified person is one who is familiar with the installation,
construction, or operation of the equipment and the hazards involved. In addition, this person has the
following qualifications:
(a)
is trained and authorized
to de-energize, clear, ground, and tag circuits and equipment in accordance
with established safety practices.
(b)
is trained
in the proper care and use of protective equipment such as rubber gloves, hard hat, safety
glasses or face shields, flash clothing, etc., in accordance with established safety procedures.
(c)
is trained
in rendering first aid.
NOTE
These instructions do not purport to cover all details or variations in equipment, nor to provide for every
possible contingency to be met in connection with installation, operation, or maintenance. Should
further information be desired or should particular problems arise which are not covered sufficiently for
the purchaser’s purposes, the matter should be referred to the local sales office.
The contents of the instruction manual shall not become part of or modify any prior or existing
agreement, commitment or relationship. The sales contract contains the entire obligation of Siemens.
The warranty contained in the contract between parties is the sole warranty of Siemens. Any
statements contained herein do not create new warranties or modify the existing warranty.
Summary of Contents for SIMPRO-100
